easyLIGHT South 10°

Aerodynamic mounting system for mounting framed PV modules on flat roofs.

On foil and bitumen roofs with and without thermal insulation under the seal as well as concrete and gravel roofs and green roofs on request

Up to 5° possible without roof anchors, above 5° only with roof anchors

Approx. 60 mm, possibly less on a gravel roof

1,200 mm (smaller edge distances on request), roof areas F and G in accordance with EN 1991-1-4 can be occupied.

950 — 1,150 mm × 1,500 — 2,250 mm (width × length)

10°, one-sided

AC 2.1 S 10 flat roof (18° internal shading angle): 527 mm, flat roof AC 2.1 S 10 (25° internal shading angle): 380 mm

Min. 1 row per 2 modules, max. 12 × 10 rows, 120 modules or 20 × 20 m

25 m (adaptation to higher buildings on request)

Suction load up to 2.4 kN/m2, pressure load AC 2.1 S 10 standard up to 2.4 kN/m2, flat roof pressure load AC 2.1 S 10 alpine up to 4.4 kN/m2

Software-based on wind tunnel tests

An adequate static load capacity of the roof structure and the building structure as well as an adequate pressure load capacity of the roof structure must be ensured on site. The general business and warranty conditions as well as the user agreement apply.

The module approval must be obtained from the module manufacturer or from the corresponding data sheet.

Module clamps with grounding pin, flat roof bracket, wind deflectors, ballast stones, ballast pans, roof anchors

Load-bearing connectors made of aluminum EN AW 6060 T64, module clamps made of aluminum EN AW 6063 T66, screws made of stainless steel A2-70, wind deflectors and ballast pans made of steel with alu-zinc coating, polyester fleece construction protection mat