All data about ALUMERO easyLIGHT South 5°

Als PDF herunterladen.

Your big plus

10 years

guarantees the best
functionality

Wind tunnel tested
Quick and easy assembly thanks to pre-assembled components
Low transport costs
Optimal module ventilation
There is water drainage on all sides
Aluminum/stainless steel main structure
No roof penetration required
Module clamps with integrated earthing pins
Lightweight and resilient
TÜV certified according to UL 2703

‍

specifications

Description

Aerodynamic mounting system for mounting framed PV modules on flat roofs.

Area of application

On foil and bitumen roofs with and without thermal insulation under the seal as well as concrete and gravel roofs and green roofs on request

roof slope

Up to 5° possible without roof anchors, above 5° only with roof anchors

connection

Min. sheet thickness

High bead trapezoidal sheet

High bead spacing

Distance from the ground

Approx. 60 mm, possibly less on a gravel roof

Distance from roof edge

1,200 mm (smaller edge distances on request), roof areas F and G in accordance with EN 1991-1-4 can be occupied.

Module orientation

Module dimensions

950 — 1,150 mm × 1,500 — 2,250 mm (width × length)

Installation angle

5°, one-sided

Row spacing

AC 2.1 S 5 flat roof (30° internal shading angle): 178 mm, flat roof AC 2.1 S 5 (15° internal shading angle): 335 mm

Max. terrain slope

Min. & max. field size

Min. 1 row per 2 modules, max. 12 × 10 rows, 120 modules or 20 × 20 m

rassemblement

Max. building height

25 m (adaptation to higher buildings on request)

Max. snow/wind load

Suction load up to 2.4 kN/m2, pressure load AC 2.1 S 5 standard up to 2.4 kN/m2, flat roof pressure load AC 2.1 S 5 alpine up to 4.4 kN/m2

roof condition

Design/stability

Software-based on wind tunnel tests

Construction requirements

An adequate static load capacity of the roof structure and the building structure as well as an adequate pressure load capacity of the roof structure must be ensured on site. The general business and warranty conditions as well as the user agreement apply.

Module approval

The module approval must be obtained from the module manufacturer or from the corresponding data sheet.

Components

Module clamps with grounding pin, flat roof bracket, wind deflectors, ballast stones, ballast pans, roof anchors

Materials

Load-bearing connectors made of aluminum EN AW 6060 T64, module clamps made of aluminum EN AW 6063 T66, screws made of stainless steel A2-70, wind deflectors and ballast pans made of steel with alu-zinc coating, polyester fleece construction protection mat.

Technical drawings